New exhaust tips from Z1

[RickW]

new exhaust tips from Z1. great quality like I expected and I'm playing around with placement. thing is my exhaust pipes bend just inside the bumper cover so it's hard to keep them straight anywhere near flush. I'm actually warming up to the way out look but will probably slide them in some even if it takes a bit of trimming. any opinions on the present look?

 

[thesilverbullet]

got pictures of the MBRP tips? I would push the z1 tips in flush or maybe a couple of inches out max.

do you think the z1 4.5 tips would fit better than the MBRP 5” tips?

Or you could try adjusting the MBRP tips with a long cheater pipe inside the tips or maybe a muffler shop can adjust them for you.

 

[RickW]

got pictures of the MBRP tips? I would push the z1 tips in flush or maybe a couple of inches out max.

do you think the z1 4.5 tips would fit better than the MBRP 5” tips?

Or you could try adjusting the MBRP tips with a long cheater pipe inside the tips or maybe a muffler shop can adjust them for you.

MBRP were way too big. these are 3.5" and they were 5". just not the look I need for my car. I can get them in a lot with some playing around

 

[malaphasis]

...

 

[alienpoker]

Three pipes might look good…

Seriously… That much stick-out is just wrong for the back of a Z. I prefer a more flush look, get a shop to help you with trimming to 2-3” & get them centered in the cut-out.

 

[RickW]

Three pipes might look good…

Seriously… That much stick-out is just wrong for the back of a Z. I prefer a more flush look, get a shop to help you with trimming to 2-3” & get them centered in the cut-out.

yes, that's my plan. I have all the tools at work so will take care of it tomorrow

 

[trackratZ]

My Stillen tips as reference, they fit the round bumper opening just right, curvature wise. Also, you might want to angle the tip of the tip to match the lower diffuser lines.

 

[trackratZ]

Three pipes might look good…

Seriously… That much stick-out is just wrong for the back of a Z. I prefer a more flush look, get a shop to help you with trimming to 2-3” & get them centered in the cut-out.

That's mickey mouse I'd say...

 

[FSUZ33]

No half measures.
Go big or stay home!