What did you do with your Z today? 🙋🏻‍♂️

[Ikazuchi6]

I wanna say the flashers were on also when I had to fill up mine. Don't quote me on that but I remember having lights on the dash that were concerning as I hadn't driven the car for months and I figured sitting up for that long had caused some battery issues. I had no clue WHAT was going on lol

 

[DBZinTN]

I wanna say the flashers were on also when I had to fill up mine. Don't quote me on that but I remember having lights on the dash that were concerning as I hadn't driven the car for months and I figured sitting up for that long had caused some battery issues. I had no clue WHAT was going on lol

Off topic, but I had my turn signals coming on solid for 1-2 seconds, off then on again. Found this and indeed the fuse was not pushed in all the way. Sloppy dealer PDI. So far so good:

• Locate the Interior Fuse Box: It is located on the driver's side of the vehicle, near the left footwell. You may need to remove a small plastic trim panel or access it from under the lower dashboard.
• Find the Transportation/Storage Fuse: Look for a prominent, oversized white plastic piece sticking out slightly from the fuse block.
• Push It In: Firmly press the white fuse assembly inward until it clicks or sits completely flush with its base to restore all electrical functions. [1]

 

[ZillaZ]

Thanks!
Did not do the Katanas.
Yes, they are overlays.

Looks great. Did you do the Katana covers too? Do the side skirts just overlay?

https://www.nissanzclub.com/forum/threads/what-did-you-do-with-your-z-today-.2677/page-118#post-161258

Not a carbon fiber guy but these look way better than the silver. Overlays and super easy to install.

 

[beergeek]

https://www.nissanzclub.com/forum/threads/what-did-you-do-with-your-z-today-.2677/page-118#post-161258

Not a carbon fiber guy but these look way better than the silver. Overlays and super easy to install.

They do look great on your car, but I haven’t done them because I’m not sure they work with a black roof.

Also, I actually like the silver.

 

[ZillaZ]

They do look great on your car, but I haven’t done them because I’m not sure they work with a black roof.

Also, I actually like the silver.

I get that with the black all over and having that contrast. Having a dark rosewood with black wheels though the silver shiny katana's didn't fit right to me.

 

[HoneybadgerPSZ]

Ordered yesterday afternoon and showed up today. Guess I have a project.

 

[HoneybadgerPSZ]

https://www.nissanzclub.com/forum/threads/what-did-you-do-with-your-z-today-.2677/page-118#post-161258

Not a carbon fiber guy but these look way better than the silver. Overlays and super easy to install.

Mine have been on back order from Axis Japan. The silver looks out of place even on my white car.

 

[ZillaZ]

Mine have been on back order from Axis Japan. The silver looks out of place even on my white car.

The ones I got from Evo-R shipped from Taiwan and took less than a week to get to me in midwest USA. I did get a notification from DHL a few days after ordering to pay duty on it. Was like $20 or something. Then a couple days after that it was on my doorstep.
I feel like I got lucky because I have heard some horror stories.

 

[thesilverbullet]

It also honks when you fill it up to the correct pressure only after the TPMS warning is initiated.

Thanks for the info - always checked & adjusted tire pressure with the tires cold and engine\switch off. this video confirms the accessory switch needs to be on.. and the flashers flash as soon as you start to add air and the horn beeps when at pressure, beeps again if you over inflate..

 

[Ikazuchi6]

1/4 of my order got delivered today.

Went with 265/35/19 fronts and 275/35/19 rear. Really wanted wider on a rear for a couple reasons...getting the speedometer closer to correct and wanting a little more bulge on the sidewall...but it would have been like $200 extra.

This set of 4 was like $620 to my door. Not complaining.

I'm under the impression the new tires are gonna make a world of difference. Gotta finish wearing out the oem set first. Can't wait!