Sponsored
3D printed RZ34 Aero Project
- Thread starter jamesmcintoshjr
- Start date
- Watchers 9
OP
OP
jamesmcintoshjr
Active Member
- First Name
- James
- Joined
- Oct 30, 2025
- Threads
- 1
- Messages
- 33
- Reaction score
- 50
- Location
- Toronto Canada
- Car(s)
- 2024 seiran blue Z
- Thread starter
- #32
Once sanded, primed and painted it looks like any other part.
OP
OP
jamesmcintoshjr
Active Member
- First Name
- James
- Joined
- Oct 30, 2025
- Threads
- 1
- Messages
- 33
- Reaction score
- 50
- Location
- Toronto Canada
- Car(s)
- 2024 seiran blue Z
- Thread starter
- #33
With one exception, printed parts are dead flat, not wavy like a lot of fiberglass parts.
OP
OP
jamesmcintoshjr
Active Member
- First Name
- James
- Joined
- Oct 30, 2025
- Threads
- 1
- Messages
- 33
- Reaction score
- 50
- Location
- Toronto Canada
- Car(s)
- 2024 seiran blue Z
- Thread starter
- #34
Almost done with my ducktail, which has a lot more rake to it than traditional ducktails. I'm trying to maintain the smooth curves / crisp edge design language from the Z so it looks more cohesive. This one's an easy print and I've speed tested it up to 100mph, there was just some light fitment tweaking. I'll release final files once I reprint the final, likely within a week or two along with the front lip, which has been performing great.
OP
OP
jamesmcintoshjr
Active Member
- First Name
- James
- Joined
- Oct 30, 2025
- Threads
- 1
- Messages
- 33
- Reaction score
- 50
- Location
- Toronto Canada
- Car(s)
- 2024 seiran blue Z
- Thread starter
- #35
just circling back on this since I'm more or less finished with the 3D-Z project, had the bodyshop colour match the printed parts perfectly and installed over the weekend-
The lip and spoiler are available to download as well, the sideskirts are still in beta...
jmjrdesign.etsy.com
The lip and spoiler are available to download as well, the sideskirts are still in beta...
jmjrdesign.etsy.com
jdm-rhd
Well-Known Member
- First Name
- rob
- Joined
- Jun 26, 2021
- Threads
- 79
- Messages
- 3,248
- Reaction score
- 6,810
- Location
- orbiting caprica
- Car(s)
- 95 hardtop supra, 93 widebody rx7, 93 stockish rx7
- Occupation
- videogame tester/skater
that turned out amazing.
any schematics or info on how you mounted everything?
any schematics or info on how you mounted everything?
OP
OP
jamesmcintoshjr
Active Member
- First Name
- James
- Joined
- Oct 30, 2025
- Threads
- 1
- Messages
- 33
- Reaction score
- 50
- Location
- Toronto Canada
- Car(s)
- 2024 seiran blue Z
- Thread starter
- #37
The front lip is pretty standard front lip, top goes in the mouth, little bit of 3m tape as it wraps around front of bumper and then a few screws. Rear spoiler is 3m tape and screws in the factory performance spoiler holes but can just be run with 3m tape.
Front bar is a mount system that's hidden.