Sponsored

NISMO front strut bar question

TexasZee

Well-Known Member
Joined
May 21, 2025
Threads
7
Messages
81
Reaction score
64
Location
Texas
Car(s)
2024 Nissan Z Performance
Complete noob here and I think I made a mistake with my install of my Nismo strut bar. The Nismo strut bar has 4 Allen screws 2 on each side that hold the 3 bar pieces together. It calls for red loctite. What I did not realize was that it called for 30ish lbs of torque. I installed the screws with red loctite and hand tightened the screws. Because I did not torque to the appropriate requirements am I screwed because I used the red loctite? Thanks
 

MCN1SMO

Moderator
Moderator
First Name
Matt (MC)
Joined
Jan 31, 2023
Threads
0
Messages
1,645
Reaction score
2,686
Location
NC
Car(s)
24 Z NISMO & #1 GTR NISMO
I have the same strut brace and did not use loctite but we did torque to 30. 30 is pretty lite ... if you gave it a good hand tightening I dont think its that far off.
 
OP
OP
TexasZee

TexasZee

Well-Known Member
Joined
May 21, 2025
Threads
7
Messages
81
Reaction score
64
Location
Texas
Car(s)
2024 Nissan Z Performance
I have the same strut brace and did not use loctite but we did torque to 30. 30 is pretty lite ... if you gave it a good hand tightening I dont think its that far off.
You’re the exact person I was hoping would respond as I’ve followed your post and build and knew you had the Nismo strut. Thanks brother.
 

MCN1SMO

Moderator
Moderator
First Name
Matt (MC)
Joined
Jan 31, 2023
Threads
0
Messages
1,645
Reaction score
2,686
Location
NC
Car(s)
24 Z NISMO & #1 GTR NISMO
yeah I mean if it was like the torque you needed on a wheel lug or something that would be different but 30 ft lbs is like a real snug hand tight. loctite shouldnt be a issue but I just didnt use it because when we put the pieces together there was a slightly raised edge and we had to tweak it a bit so we took it back apart a couple times
 
 






Top