Maximus
Well-Known Member
- Thread starter
- #1
Looking for some assistance ordering spacers.
I just had my car aligned yesterday and am at -2.5 camber in the rear and -2.7 up front. Wheel specs are 10.5 +15 in the rear and 9.5 +20 up front. Running 275 in the rear and 255 up front. Sorry if that was too much info….lol
You can see in my pics is measured about where the sidewall starts to tread and head back at an angle towards the contact patch of the tires (both front and back). Both front and rear are showing about an inch inset from the fender.
Question is: would 20mm in the rear and 15 up front widen the stance enough so that I’m just inside flush without risking rubbing (or at least too much)?
Thanks,
Chris
I just had my car aligned yesterday and am at -2.5 camber in the rear and -2.7 up front. Wheel specs are 10.5 +15 in the rear and 9.5 +20 up front. Running 275 in the rear and 255 up front. Sorry if that was too much info….lol
You can see in my pics is measured about where the sidewall starts to tread and head back at an angle towards the contact patch of the tires (both front and back). Both front and rear are showing about an inch inset from the fender.
Question is: would 20mm in the rear and 15 up front widen the stance enough so that I’m just inside flush without risking rubbing (or at least too much)?
Thanks,
Chris