Well well - looks like ecutek can control the stock pump - may not need to change the pump and controller?
1. Activating and Driving the Pump (System Bleeding)
When installing an upgraded aftermarket heat exchanger (such as AMS, Z1, or Racebox), trapping air in the lines is highly common and...
Stillen starting to look good. Can easily cut more threads on the shaft to drop the ball and looks like you could replace the isolator bushing with polyurethane - or is it already polyurethane?
i like the assembly - easy to replace the isolator bushing.
that end looks good (maybe a Delrin bushing) i wonder what they did with the isolator on the top side - not much shorter, but that could be increased with a short recessed ball.
also looking at short shifters.
any idea how the new shifter is different to tighten up the shifts - polyurethane vs rubber? - it still has an isolator for vibration. I’m guessing vibration took priority…
looks like they are still using the same nylon ball socket cup
Sound is awesome. It’s louder than stock (but not that much) with a much more aggressive note especially at WOT. she fairly quiet when cruising.
tuning is coming - shooting for first week of December.
when i installed the stock a/t axle back on my m/t, i was getting buzzing noises behind the seats \ crossbar area. No buzzing since i installed the AWE Touring exhaust.
I have the 3” race spools - fitment is spot on except for the support brackets and the passenger side o2 sensor - the o2 wire harness is barely long enough to reach and the support bracket mounts are way off and do not mate up to the factory brackets. I have been running these since may without...
easy - did it all by myself. after removing all the clips and bolts from the top and bottom shrouds, i removed the front 2 bolts behind the fender liner, two wire harness clips and pulled the clips loose under each headlight in that order
i pulled one clip on the fender liner to help get to the...