Can somebody please take a measurement on their Z Nismo?

[up4speed]

I need to replace the Nismo emblem on my rear bumper, and wanted a measurement from a fixed point, so I can make sure that the emblem is centered properly.
It's really difficult to center due to it's shape.
Can someone please take a fixed point (such as the edge of the back up sensor, etc), and measure from the left to the edge of the "N" and on the right side, from a fixed point on the right, to the edge of the "O"? I would really appreciate any help. I really want to know that it is in the factory position.

 

[sdktheway]

just so i understand right, you are looking for these two distances, X and Y?

also I need to wash my car ?

 

[up4speed]

just so i understand right, you are looking for these two distances, X and Y?

also I need to wash my car ?

Yes, that would be perfect! Thank you

 

[sdktheway]

Okay so some terrible photos but from the left side-->N is about 9.5 inches exactly, but the O--->Right side measurement is about an 8th of an inch longer ~9.625 inches. I can get you some better photos tomorrow if it helps.

 

[up4speed]

Okay so some terrible photos but from the left side-->N is about 9.5 inches exactly, but the O--->Right side measurement is about an 8th of an inch longer ~9.625 inches. I can get you some better photos tomorrow if it helps.

Thank you! The more info you can give the better, I really appreciate it!
I think those photos show what I needed.