I'm so glad I searched this, thank you!
2 play money plastic coins in each popper (even cheaper than the real thing) and BOOM my hatch pops straight up.
Yep! I just put the adjustable buckets in with the camber arms. Now wanting to go lower and wondering if I need the FUCAs.
All part of the fun I guess!
I cant wait to put mine in!! They're sitting in a box until a Y pipe arrives next month, then it's DP and tune time BABY!
I can confirm they are absolutely beautiful!
I ended up going with some parts from a local aussie brand gktech - camber arms, adjustable toe spring buckets, and two eccentric delete kits.
The toe buckets aren't as sexy (or expensive) as the nismo or SPL ones, but they play nice with the HKS springs while also allowing me to run any 2.5"...
Below is 33mm drop front 25mm rear which is factory height for HKS coilovers.
They will mostly settle after a short drive. HKS recommend 50kms, mine did the majority of settling after the first drive, I got 1-2mm extra after 50kms or so.
And yes, it's pretty sketchy to drive before the...
Good choice, I pretty much always run my mishimotos with the lids off so I'll probably go boosted 6 down the line for even more sounds. It was fiddly but not too bad, the boosted 6 would be even easier without the airboxes.
I didn't find the clips difficult, I just jammed two flathead...
Obviously HKS wasn't the cheap option, but every set of replacement buckets I've seen switch the springs to a 2.5" ID.
Actually, I need to look a bit more into it, the HKS main spring is wider but it's the helper spring that sits on the perch and that might be 2.5" ID and fit the aftermarket...
I found a neat solution to getting proper toe once lowered with the Z1 eccentric kit.
https://www.z1motorsports.com/components/z1-motorsports/z1-rear-toe-camber-eccentric-bolts-p-58876.html
You use the template to widen the adjustment holes and then replace the bolts with new wider adjustment...
I got the alignment done and HOLY what a difference the coilovers make. The car feels so gripped up now even on the stock tyres, and putting the power down is a lot safer.
Once settled the drop was 33mm at the front and 25mm rear, prior to lowering the front guards were 3mm higher than the...
It does put more load on them by creating a larger distance from the wheel bearing to the attachment point, which will wear them faster. However as mentioned, it's not a massive increase in load with the size we typically use on the Z's, and wheel bearings are overbuilt and cheap to replace...
Hi pals, I'm new to the world of aftermarket wheels and tyres and hoping some of you knowledgeable folk can help confirm my research. Many thanks in advance!
My Z (I think it's called the Performance model in USA) has the stock wheels and tyres, which I believe are as follows:
Front: 19x9.5 +40...
I've worked on mountain bikes but never a car. There's nothing technical about the install, if you've got the tools and the patience then you should give it a go!
With the lids on you don’t get much noise inside the car but it’s more than the stock intakes.
With the lids off driving around the car sounds insane! I’ll be surprised if I ever put them back on outside of very hot days.