Search results

You can't do it for free. It changes the throttle curve or "expo" of the curve, not the speed of you pressing the throttle. I have one on my Z because I felt the car was slow to accelerate then jerky when it catches up. Now I have the Ultimate 9 EVCX and on setting 4 it has a much more flat line...

A bit of everything, brackets, tools all sorts of stuff. Dont bother with PLA, go straight for the Petg or ASA or ABS for car parts

Bambo lab A1, cant fault it, had it for 6 months, not one failed print or error, put about 4 or 5kgs of fillament through it.

I do mine in 15 minutes, foam, rinse, soap, rinse, then rinse again with reverse osmosis and D.i water. I'Il contact wash every 5 or 6 washes if needed but otherwise the 15 minute wash is completely touch free. 1.5 years later and not one swirl mark, even on th black roof.

wish we did get two specs but only the one for us.

mine has power folding mirrors

Yeah, pretty sure it comes out the sub as well.

The sound will be all out of wack. Also the fake engine noise will be super loud and too much bass

The stock bose amp that powers 2x 4 inch "subs" wont be enough to power a 12 inch sub

I didn't notice a difference.

I think with these these modern ABS circuits, its not as important as each wheel is independant to eachother. Even though I alsways do furtherest to shortest in relation to the master cylinder.

Yeah sorry about the fluff, thats the way my videos go, I go on tangents very easy. Yes, easy install. It can be completely disconected with no trace in under 10 mins then put back on when you get back after going to the dealers. Check out my other videos with some of the other little things I...

Yes I had them both turned off a couple months back in hopes that by doing that, it would improve the sound of the stereo, it didn't. I think it made it sound worse.

Anyway, I took a chance, and it all worked out perfectly. I used an 8-gauge fused wire from the battery to the boot, threading it through the grommet located right behind the battery (see the third picture). My battery is on the left side of the car since I'm in Australia—I'm not sure if...

Lots of info but not what I'm after. I need to know what the 4 wires that feed the existing sub are. I assume 2 are negative and 2 are positive and I probably only need 1 set of them to feed to the new amp but I want to make sure before I go sticking unknown wires into things. The diagram shows...

Good morning. I'm looking to upgrade the subwoofer in my 24 Z and am considering the Kenwood Spare Tyre Sub to replace the stock Bose unit. For those who have made this upgrade, could you please advise on which wires to use from the old sub connection to connect to the amp of the new Kenwood...