Sponsored

Recent content by RZ34>Mk.V

  1. Installed the cheap hoodlifts

    Any issues with hood fitment when closed? My friend installed a pair and afterwards, there was a slight bulge (maybe 1mm - 1.5mm) on the hood where the struts are mounted
  2. Lowering springs question

    Please post pics. Before and after if you have it. TIA
  3. Suspension and spacers installed

    They look great! After looking at their website, seems they have 2 different versions. Which ones did you get? The NS-003-SS or the NS-002-SS? and the 1 3/4" drop, is that the highest. lowest, or just what you set it at? What is the height range for the set you got? Thanks!
  4. Invidia Germini catback

    I noticed a rattle/vibration behind the dashboard near the doors after installing a B6A resonated lower downpipe. It went away though after a short while. I don't know what causes it. All clearances were fine and all bolts checked for tightness after inspecting the car on a lift. The Invidia...
  5. Invidia Germini catback

    I was impressed with the look, sound, performance, and overall quality as well especially at such a good price compared to other exhausts. Clean welds. Very nice materials used. Very nice design and consistent diameter pipe bends. I love the deeper sound from the 2 3/4'" (70mm) piping as...
  6. Invidia Germini catback

    And here's a clip after getting a K&N Cold Air Intake.
  7. Invidia Germini catback

    Here's a clip after installing a Boosted 6 resonated lower downpipe. Noticeably louder, and even deeper exhaust note. Still no drone :) I got the Invidia Gemini over the Invidia N1 as I knew I may get a lower downpipe in the future and didn't want an exhaust that was too loud.
  8. Invidia Germini catback

    Here's a clip with just the Invidia Gemini exhaust. Best with earphones. No drone :) Deep sound, but not loud enough to be annoying.
  9. Invidia Germini catback

    I had the exact same issue with one of the exhaust tips on my Invidia Gemini. Oddly enough, there was another Z getting the same exhaust installed and had no issues. After a glance, I figured out that all it needed was a washer (+2mm) to push the clamp enough to be tightened with the supplied...



Top